Premier Mounts PSD-VHSA - Manual (Page 3)

- 3 -
The floor or tabletop structure must be capable of supporting at least five (5) times the weight of plasma display. If not, the floor or tabletop
must be reinforced. Proper installation procedure by qualified personnel as outlined in the installations instructions must be adhered to.
Failure to do so could result in serious personal injury
The entire installation instructions should be fully read and understood, including all of the safety symbols and safety precautions, before
beginning installation. The installation instructions should be read, understood and followed to prevent personal injury or property damage.
Keep these installation instructions in an easily accessible location for future reference.
Indicates that the power plug is to be disconnected from
the power outlet.
Safety precautions must be taken at all times.
Contact Premier Mounts for any questions
Warning and caution in general
A suitable floor or tabletop must always support the weight or load of the plasma. Always confirm the weight load of the installation
structure before installing the PSD-VHSA stand.
Do not install in locations where there is vibration, movement or danger of impact. Failure to do so could result in plasma cracking or
tipping over from the floor or tabletop causing damage to the plasma and injury.
Do not install near heater, fireplace, direct sunlight or air conditioning or any other source of direct heat energy. Failure to do so may
result in damage to the plasma display.
At least two qualified people should always perform the installation work. Injury and damage can result from dropping or mishandling
the plasma display.
Safety & Precautions
WARNING : Safety precaution measures must be practiced at all times during the installation of this product. Use proper safety gear and tools for the
installations procedure to prevent personal injury or damage to the plasma displays or plasma mounts.