Pioneer PDP-S43-LR - Manual (Page 6)

Right
Left
Speaker units ( X 2)
Operating Instructions
(this instructions)
Connection cord ( X 2)
Screw (M4) ( X 4)
Cushion ( X 2)
Cord Clampe ( X 2)
PDP-S43-LR
Check that the following items are included in the delivered package.
If any of the following items is missing or defective, immediatly contact
your dealer.
Checking the Package Contents
Operating Instructions
Thank you for purchasing the PDP-S43-LR Speaker System.
Before using this product, please read this Operating Instructions Manual thoroughly so that you can
use this product at its full functionality.
After reading, retain this Operating Instructions in an easily accessible location so that you can refer to
this Operating Instructions whenever you have a problem or trouble during use.
This product is exclusively for use with Pioneer 50-inch plasma display (PDP-50FX10•PDP-50FXE10).
Do not connect to anything other than the PDP-50FX10•PDP-50FXE10. Doing so could result in malfunction
or fire.
Note
This speaker is of an antimagnetic design; however, depending on its placement, for example,
bringing the speaker into the vicinity of a monitor other than a plasma display, the speaker may cause
irregular color or other effects. Should this occur, please move the speaker away from the display.
Notes on Installation Work:
This product is marketed assuming that it is installed by
qualified personnel with enough skill and competence.
Always have an installation specialist or your dealer install
and set up the product.
PIONEER cannot assume liabilities for damage caused by
mistake in installation or mounting, misuse, modification or
a natural disaster.
In order to prevent damage to the speaker
system resulting from input overload, please
observe the following precautions:
Do not supply power to the speaker system in excess of
the maximum permissable input. This can result in
damage or a possible fire hazard.
When connecting or disconnecting pin-plugs, be sure
that amplifire power is OFF.
When using a graphic equalizer to emphasize loud
sounds of a high frequency range, do not use excessive
amplifier volume.
Do not force a low-powered amplifire to produce a loud
volume of sound (the amplifire's harmonic distortion will
be increased, and you may damage the speaker).