Python 323 - Manual (Page 11)

8 © 2009 Directed Electronics. All rights reserved.
Basic Commands (Direct Access)
No ghost LED’s on
Arm
Press and release
The alarm arms, doors lock (if connected), and the siren chirps and
parking lights flash once. The arm LED and beeps play to confirm. If
valet mode* is on, the doors lock and the arm LED,
LED and a fault
tone plays. Exit valet mode to arm the alarm normally.
If a trigger zone fault is detected the siren chirps once again and the
remote will emit a trigger zone fault report**, the arm LED,
LED and
a fault tone plays.
To Arm and Panic
Press and hold
The alarm arms (or locks in valet) and, after 2 seconds, sounds
the siren and flashes the parking lights. The ghost LED’s flash and
siren tones play to confirm. Press the
or button to stop the
output.
Disarm
Press and release
The alarm disarms, doors unlock (if connected), and the siren chirps
and parking lights flash twice. The disarm LED and beeps play to
confirm. If valet mode* is on, the doors unlock and the disarm LED,
LED and fault tones play.