Profoon Telecommunicatie TX-255 User Manual

Page 9

1. Ringer Volume Selection

2. Redial Function

3. Speaker Function

4. Flash Function

5.Mute Function

6. Pause Function

HI/LO

RD./P

FLASH

NOTE:

FLASH

MUTE

MUTE.

MUTE

Set the ringer volume switch to the desired position (

) to select

the ringer volume. To have the maximum ringer volume, move the
ringer volume switch to the

position. If you would prefer a gentle

ringer volume, move the ringer volume switch to the

position.

Lift the handset or press the

button, then press the

button to

redial the last dialled number.

To switch your call to speakerphone, press the

button and hang up

the handset. To revert back, just pick up the handset. In speaker state,
you can dial the number and receive the call, also you can answer the
call.

Press the

button to terminate a call and institute a dialling tone

for another call or to get another call from "Call Waiting" (a special
telephone service).

If you do not have any special telephone service, such as Call

Waiting, pressing the

button during a call may disconnect your

current conversation.

If you wish to speak privately to someone else in the room without
your caller overhearing, press the

button once then the LCD will

display

To resume normal conversation, just press the

button again.

Allows you to insert a temporary pause during dialling sequence. For
example, dialling an international number (eg: 011-886-22-795-1234),
some telephone company systems will not register the entire number

FUNCTION BUTTONS

6. FLASH TIME SETTING

7. HOUR FORMAT SELECTION

8. DATE FORMAT SELECTION

Press the

button to enter this setting when the LCD shows

and then the current value will display.

Use the

button to set the flash time (100ms/120ms/300ms/

600ms). Press the

button to confirm and exit.

Press the

button to enter this setting when the LCD shows

and then the current value will display.

Use the

button to select the hour format (12H/24H). Press

the

button to confirm and exit.

Press the

button to enter this setting when the LCD shows

and then the current value will display.

Use the

button to select the date format (DD-MM/MM-DD).

Press the

button to confirm and exit.

In the DD-MM mode, the time display sequence is day-month and
in the MM-DD mode, the sequence is month-day.

SET

FLASH

HOUR

FORMAT

DATE

FORMAT