Peavey TRANSTUBE 110 EFX - Manual (Page 29)

29
TECHNISCHE DATEN DES TRANSTUBE® 110 EFX
Änderungen der technischen Daten vorbehalten.
POWER AMP SECTION:
Rated power and load:
40 Watts (RMS) into 6 Ohms
Power @ clipping (typically):
(5% THD, 1 kHz, 120 VAC line)
35 Watts (RMS) into 6 Ohms
Total harmonic distortion:
Less than 0.5% THD, 100 mW to 15 Watts (RMS),
100 Hz to 10 kHz
Power amp hum and noise @ nominal input
level:
(20 Hz to 20 kHz, unweighted)
Greater than 82 dB below rated power
Power Consumption:
75 Watts 50/60 Hz, 120 VAC
PREAMP SECTION:
The following specs are measured @ 1 kHz
with the controls preset as follows:
Channel select: CLEAN
EQ voicing switch: MODERN
Low, mid, and high: 5
Pre gain and post gain: 10
Efx adjust: OFF
Reverb: OFF
Delay: OFF
Volume (nominal level): 5
Volume (minimum level): 10
Preamp input (clean channel):
Impedance: High Z, 250 k Ohms
Nominal input level: -14 dBV, 200 mV (RMS)
Minimum input level: -24 dBV, 64 mV (RMS)
Effects send:
Output impedance: 1k Ohms
Nominal output Level: -7.4 dBV, 425 mV (RMS)
Effects return:
Input impedance: 31 k Ohms
Nominal input level: -7.4 dBV, 425 mV (RMS)
Headphone output:
Load impedance: 8 Ohms or greater
Nominal Power Output: 30 mW (RMS) into
8 Ohms
(Stereo jack, monaural signal disconnects
internal speaker when phone plug is inserted.)
System Hum and noise @ nominal input
level:
(20 Hz to 20 kHz, unweighted)
Greater than 75 dB below rated power