Parkside PFS 710 - Manual (Page 7)

L Understood everything?
J
When you have made yourself familiar with
these general safety instructions for electrical
hand tools, and, with the help of the appropriate
operating instructions, are familiar with the
functions and handling of your electrical hand
tool, then you can start with the work. Then, you
will work at your safest under consideration
of the declarations and instructions of the
manufacturer.
Important safety instructions
specific to the tool
J Do not cut materials containing asbestos.
J When sawing building materials, observe the
statutory requirements and the manufacturer’s
recommendations.
J Caution! Never allow the blade to come into
contact with a solid object or the floor when the
tool is operating – danger of kick-back!
J Make sure that the tool is operating before you
bring it into contact with the workpiece.
J The course of the cut must have no obstructions
above or below it. When you switch on the tool,
ensure that the blade is not resting on, interfering
or in contact with any object.
The footplate g must always be set against the
workpiece when the tool is sawing.
J Hold the tool firmly with both hands at all times
when working. Keep proper footing and balance.
J Do not put the tool down before it has been
switched off and has reached a standstill.
J Caution! Do not remove the saw blade from
the workpiece until it has come to a standstill
– danger of kick-back!
J
Use only sharp, defect-free blades. Replace
cracked, bent or blunt blades immediately.
L
Information about saw blades
The Parkside basic equipment already contains saw
blades for the most common main applications.
You can also use all other saw blades, assuming
they are provided with a suitable
1 /
2
“ universal
shaft receptor. Optimal saw blades suitable for all
application purposes for a sabre saw are available in
various lengths from traders overall.
Note: TPI = teeth per inch / 2.54 cm
Wood-sawing blade l :
Dimensions: 240 x 1,5 mm, 5 TPI
Best suitability: for sawing nail-free rough wood up
to 190 mm in a fast rough cut
Wood-sawing blade m :
Dimensions: 240 x 1,5 mm, 3 TPI
Best suitability: for sawing rough wood, also fire-
wood, up to 190 mm in a fast rough cut.
Universal saw blade n :
Dimensions: 150 x 1,25 mm, 6 TPI
Best suitability: for sawing building timber, plywood,
blockboard and chipboards, also for plunge cuts.
Flexible saw blade o :
Dimensions: 150 x 0,9 mm, 10 TPI
Best suitability: for sawing wood, also with nails,
as well as plastics.
L Before taking into use
L
Inserting / replacing saw blades
j Remove the mains plug from the socket before
carrying out any tasks on the tool!
j Protect yourself from being injured by sharp
blades. Wear appropriate protective gloves
when fitting and testing the blade.
j Before replacing the blade, make sure that it is
free of any cutting residue (e.g. wood splinters).
j
If necessary, clean out the saw
blade mounting recess with a
thin paintbrush or by compressed air.
1. Unscrew the hexagonal socket head screw f
using the supplied hexagonal socket screw key e .
2. Feed the saw blade between the plunger i and
the clamp plate k .
Make sure that locating pin j engages in the
Safety / Before taking into use
9 GB/IE