Pioneer DEH-1000E - Manual (Page 6)

4 TP indicator
Shows when a TP station is tuned in.
5 TA indicator
Shows when TA (traffic announcement
standby) function is on.
6 RPT indicator
Shows when repeat play is turned on.
7 LOUD indicator
Appears in the display when loudness is
turned on.
8 Stereo (5) indicator
Shows when the selected frequency is
being broadcast in stereo.
9 LOC indicator
Shows when local seek tuning is on.
Basic Operations
Turning the unit on and
selecting a source
You can select a source you want to listen to.
To switch to the built-in CD player, load a disc
in the unit (refer to page 9).
% Press SOURCE to select a source.
Press
SOURCE repeatedly to switch between
the following sources:
Tuner
—Built-in CD player—AUX
Notes
! In the following cases, the sound source will
not change:
— When there is no disc in the unit.
— When AUX (auxiliary input) is set to off
(refer to page 11).
! AUX is set to on by default. Turn off the AUX
when not in use (refer to Switching the auxili-
ary setting on page 11).
! When this unit’s blue/white lead is connected
to the vehicle
’s auto-antenna relay control
terminal, the vehicle
’s antenna extends when
this unit
’s source is turned on. To retract the
antenna, turn the source off.
Adjusting the volume
% Use VOLUME to adjust the sound level.
Turning the unit off
% Press SOURCE and hold until the unit
turns off.
Tuner
Listening to the radio
1 Press SOURCE to select the tuner.
2 Press BAND to select a band.
Press BAND until the desired band (F1, F2 for
FM or MW/LW) is displayed.
3 To perform manual tuning, briefly press
c or d.
4 To perform seek tuning, press and hold
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by briefly pressing
c or d.
# If you press and hold c or d you can skip sta-
tions. Seek tuning starts as soon as you release
the button.
Operating this unit
En
6
Section
02