Pentair EASYTOUCH EZ100 - Manual (Page 6)

P/N 520041 6 Rev. D
2-19-04
SECTION XI. CUSTOMIZING THE COMMUNICATION LINK
The communication link between the Receiver and Hand-held Remote can be customized to prevent electrical
interference. To accomplish this, there is a 10-position configuration switch located on the Receiver circuit board
and inside the Hand-held Remote. Units are shipped from the factory with all switches in the “ON” position.
If you wish to change this setting, use the corner of a paper clip or other blunt instrument and adjust both
10-position configuration switches to matching settings. If the configuration switch setting at the Receiver does
not match that of the Hand-held Remote, the communication link will not function.
Labels have been provided, marked with the most commonly used functions. These labels may be affixed to the
side of the Hand-held Remote to assist with button identification.
Receiver Transmitter
S1
Switch
COMMUNICATION LINK ADJUSTMENT
NOTE: All Program Switches are Factory set to “ON”.
Matching Code Example: Remote switches 2, 4, 6 “ON”. Receiver switched 2, 4, 6 “ON”.
Affix
Button
ID
Labels
Here
SECTION XII. TRANSMITTER BATTERY REPLACEMENT
With normal use, the battery should last for several years. In the event the battery must be replaced, slide the cover
from the bottom of the Hand-held Remote. Slide the battery from the retainer clip and discard in accordance with
local and/or state ordinances. Replace with 3V lithium battery number CR2032 or equivalent. Slide battery cover
onto remote and snap in place.