PYLE Audio PLCD26 - Manual (Page 3)

TROUBLE SHOOTING
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
Symptom
No power
Disc cannot
be loaded or
ejected
Cause
The fuse is blown
Presence of CD disc inside
the player
Inserting the disc in upside
down
Compact disc is extremely
dirty or defective
Temperature inside the
car is too high
Condensation
Volume is in minimum No sound
Sound skips
The antenna cable is not
connected
the signals are too weak Insert the antenna cable firmly
select a station manually
The radio does
not work
Wiring is not properly
connected
The installation angle
is more than 30 degrees
The disc is extremely
dirty or defective Clean the compact disc/try to
play a new one
Adjust the installation angle
to less than 30 degrees
Adjust volume to a desired level
Check wiring connection
Leave the player off for an
hour or so, then try again
Cool off until the ambient
temperature returns to normal
Clean the disc or try to play a
new one
Insert the compact disc with
the label facing upward
Remove the disc in the player
then put a new upward
Replace the fuse
The car ignition is not on. If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
Solution
6. OPEN BUTTON
Press it to flip down the front panel when you want to take away.
Press it to flip down the front panel then you can insert a disc into the
compartment or eject the disc by pressing the EJ button.
5. TUNING BUTTON
During tuner mode, rotate it to select your desired radio broadcasting
station within FM/MW.
4. LCD ( LIQUID CRYSTAL DISPLAY)
Press it to eliminate the sound temporarily when you need, press it again
to resume normal play state.
9. MUTE BUTTON
7. POWER BUTTON
Press it to turn on or off the unit.
TREBLE CONTROL
a. Press the SEL button to select the treble mode until TRE appears on the display.
b. Press + or - to adjust the treble effect.
BALANCE CONTROL
FADER CONTROL
a. Press the SEL button to select the balance mode until BAL appears on the display.
a. Press the SEL button to select the fader mode until FAD appears on the display.
b. Press the + button or - button to increase or decrease the sound level of
b. Press the + button or - button to increase or decrease the sound level of
left or right speaker.
front or rear speaker.
8. BAND BUTTON
At CD mode, press it to switch tuner mode.
Press it to select your desired radio band and the band which is selected
will be displayed on LCD.
10. MO/INT BUTTON
MO MODE: Press it to select mono or stereo mode.
INT MODE:
During CD mode, press " INTRO "button to hear the first 10 seconds
of each track on the disc. Press this button again to restore the
player to its normal play mode.