Service, Storage – Poulan GHT 180 LE User Manual

Page 6

-- 6 --

STARTING A FLOODED ENGINE

Flooded engines can be started by placing

the ON/OFF switch in the ON position and the

choke lever in the OFF CHOKE position and

engaging the throttle lock as directed in the

STARTING A COLD ENGINE section; then,

pull the rope to clear the engine of excess

fuel. Starting could require pulling the starter

rope many times depending on how badly the

unit is flooded. If the unit still doesn’t start, refer

to the TROUBLESHOOTING TABLE or call

1-800-554-6723.

SERVICE

WARNING:

Ensure ON/OFF switch

is in the OFF position and disconnect the

spark plug before performing maintenance

except for carburetor adjustments.

We recommend all service and adjustments

not listed in this manual be performed by an

authorized service dealer.

CLEAN AIR FILTER

Air Filter

Cover

Screw

Air Filter

Cleaning the air filter:

A dirty air filter decreases engine perform-

ance and increases fuel consumption and

harmful emissions. Always clean after every

5 hours of operation.
S

Clean the cover and the area around it to

keep debris from falling into the carburetor

chamber when the cover is removed.

Remove parts as illustrated.

NOTE:

Do not clean filter in gasoline or other

flammable solvent. Doing so can create a fire

hazard or produce harmful evaporative emis-

sions.
S

Wash the filter in soap and water.

Allow filter to dry.

Add a few drops of oil to the filter; squeeze

filter to distribute oil.

Replace parts.

INSPECT MUFFLER AND SPARK

ARRESTING SCREEN

WARNING:

The muffler on this prod-

uct contains chemicals known to the State of

California to cause cancer.

As your unit is used, carbon deposits build up

on the muffler and spark arresting screen and

must be removed to avoid creating a fire haz-

ard or affecting engine performance.

For normal homeowner use, the muffler and

spark arresting screen will not require any

service. After 50 hours of use, we recom-

mend that your muffler be serviced or re-

placed by an authorized service dealer.

CARBURETOR ADJUSTMENT

Your carburetor is equipped with limiter caps.

Damage will occur if you turn the needles be-

yond the limiter caps. Carburetor adjustment is

a complicated task. We recommend that you

take your unit to an authorized service dealer.

IGNITION TIMING

Ignition timing is fixed, non-adjustable.

SPARK PLUG

Replace spark plug yearly with a Champion

RCJ-7Y plug. Spark plug gap is 0.025 inch.

STORAGE

WARNING:

Perform the following

steps after each use:
S

Allow engine to cool, and secure the unit

before storing or transporting.

Store unit and fuel in a well ventilated area

where fuel vapors cannot reach sparks or

open flames from water heaters, electric

motors or switches, furnaces, etc.

Store unit with all guards in place. Position

unit so that any sharp object cannot acci-

dentally cause injury.

Store unit and fuel well out of the reach of

children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if

it will not be used for 30 days or more.

If your unit is to be stored for a period of time:
S

Clean the entire unit.

Store in a clean dry area.

Clean all parts and check for damage.

Have damaged parts repaired or replaced

by an authorized service dealer.

Keep all nuts, bolts, and screws tight.

Lightly oil external metal surfaces, includ-

ing the blade.

To oil the blade, do the following:

Stop the engine and allow blade to come to

a complete stop.

Ensure ON/OFF switch is in the OFF posi-

tion.

Disconnect the spark plug wire.

Apply a light machine oil along the edge of

the top strap as shown.

Top Strap

OIL