PGS S27R - Manual (Page 10)

10
SAFETY PRECAUTIONS
IF YOU SMELL GAS:
1. Shut off gas to the appliance.
2. Extinguish any open flames.
3. Open lid.
4. If odor continues, immediately call your gas supplier.
CALIFORNIA PROPOSITION 65 –WARNING The burning of gas
cooking fuel generates toxic byproducts, which are on the list of
substances that are known by the State of California to cause cancer
or reproductive harm. California law requires businesses to warn
customers of potential exposure to such substances. To minimize
exposure to these substances, always operate this unit according to
this manual, ensuring you provide good ventilation when cooking with
gas. This warning is issued pursuant to California Health & Safety
Code Sec. 25249.6
SAFETY PRACTICES TO AVOID PERSONAL INJURY
When properly cared for, your grill will give safe, reliable service for
many years. However, extreme care must be used since the grill
produces intense heat, which can increase accident potential. When
using this appliance, basic safety practices must be followed, including
the following:
Read this Manual carefully and completely before using your
grill to reduce the risk of fire, burn hazard or other injury.
Begin by ensuring proper assembly. Do not repair or replace any
part of the grill unless specifically recommended in this manual. All
other service should be referred to a qualified technician. For
personal safety, wear proper apparel. Loose fitting garments or sleeves
should never be worn while using this appliance. Some synthetic
fabrics are highly flammable and should not be worn while cooking.
Never let clothing, pot holders or other flammable materials come in
contact with or too close to any grate, burner or hot surface until it has
cooled. Fabric may ignite and result in personal injury.
Use only dry potholders: moist or damp potholders on hot surfaces
may cause burns from steam. Do not use a towel or bulky cloth in
place of potholders. Do not let potholders touch hot portions of the
grilling grids. Only certain types of glass, heatproof glass ceramic,
earthenware, or other glazed utensils are suitable for grill use. Use of
these types of materials may break with sudden temperature changes.
Do not use aluminum foil to line the grilling grids or grill bottom. This
can severely upset combustion airflow or trap excessive heat in the
control area. The result of this can be melted knobs, igniters and
increased chance of personal injury.
Children should not be left alone or unattended in an
area where the grill is being used. Never allow them to
sit, stand or play on or around the grill at any time. Do
not store items of interest to children around or below
the grill.
Do not heat unopened food containers as a build-up of pressure may
cause the container to burst. Use a covered hand when opening
the grill lid. Never lean over an open grill. When lighting a burner,
always pay close attention to what you are doing. Be certain you are
depressing the igniter button. When using the grill: do not touch
the grilling grids, burner, casing or immediate surrounding area as
these areas become extremely hot and could cause burns.
For proper lighting and performance of the burner, keep the ports
clean. The burner will only operate in one position and must be
mounted correctly for safe operation. Clean the grill with caution.
Avoid steam burns; do not use a wet sponge or cloth to clean the grill
while it is hot. Some cleaners produce noxious fumes or can ignite if
applied to a hot surface.
Insect Warning. Spiders and insects can nest in the burner of this
and any other grill, and cause the gas to flow from the front of the
burner. This is a very dangerous condition, which can cause a fire to
occur behind the valve assembly, thereby damaging the grill and
making it unsafe to operate.
Do not operate the grill under unprotected combustible construction.
Use only in well ventilated areas. Do not use in buildings, garages,
sheds, breezeways or any enclosed areas. Keep the area
surrounding the grill free from combustible materials, trash, or
combustible fluids and vapors such as gasoline or charcoal lighter fluid.
Do not obstruct the flow
of combustion and ventilation air.
If the unit is stored indoors ensure that it is cool. The propane cylinder
must be unhooked and stored outside in a well- ventilated area, out of
reach of children. Never use the grill in windy conditions. If located
in a consistently windy area (oceanfront, mountaintop, etc.) a wind-
break will be required. Always adhere to the specified clearance.
LOCATION
When determining a suitable location, take into account concerns such
as exposure to wind, and proximity to traffic paths. Locate the grill
only in a well-ventilated area. Never locate the grill in a building,
garage, breezeway, shed or other such enclosed areas with out an
approved ventilation system. During heavy use, the grill will produce a
lot of smoke. Grill should be placed on a sturdy, level surface.
CLEARANCE
To Non-Combustible Construction
A minimum of 6” clearance from the back of the grill to
non-combustible construction is required.
To Combustible Construction
A minimum clearance of 30" between the grill and any
combustible materials is required. This includes above,
below, and side of the grill as all surfaces produce heat.
ASSEMBLY INSTRUCTIONS
Below instructions are for a LEGACY grill on a Portable Cart. If you
are installing in a masonry application, skip to step #12.
If your grill has an Infra-Broil Rear Burner, see page 14 for
use and care instructions. If you purchased an optional Side
Burner Kit, see page 14 for installation and use instructions.
Cut bands off of outer cartons of the grill head and also the cart.
With two people lift the outer carton off the pallets.
1. Carefully remove all plastic and packaging, break top half of
Styrofoam form encasing grill head away from grill. Put
grill head aside, ASSEMBLE CART FIRST.
2. Inside cart box your will find:
a. 4 shelf brackets labeled (2each) left and right
b. 2 side shelves
c. 2 locking wheels
d. 2 non locking wheels
e. 1 interior shelf (for 36” cart only)
f.
Hardware bag which includes
Qty 16 8mm screws
Qty 16 8mm flat washers
Qty 16 8mm spring (lock) washers
3. Remove doors from cart by lifting them off pegs
4. Flip cart so it is upside down, put a flat washer and then a
locking washer on each of the (16) 8mm screws.
5. Place the 2 locking casters on the same end of the cart
(makes no difference which) and attach to cart by inserting
screw/flat washer/lock washer in each of the four
pre-attached nuts. DO NOT TIGHTEN UNTIL ALL FOUR
ARE STARTED. DO NOT CROSS THREAD. Screws can