Peavey IDC 150T II - Manual (Page 6)

6
Due to our efforts for constant improvements,
features and specifications listed herein are subject to change without notice.
SPECIFICATIONS
(all measurements @ 120 V AC, 60 Hz or 24 V DC)
Rated Output Power: (typical value)
AC powered, continuous sine wave:
70 volt line 32.7 ohms, 1 kHz, 1% THD: 150 W RMS
25 volt line 4.2 ohms, 1 kHz, 1% THD: 150 W RMS
24 V DC battery powered, continuous sine wave:
70 volt 32.7 ohms, 1 kHz, 1% THD: 100 W RMS
25 volt 4.2 ohms, 1 kHz, 1% THD: 100 W RMS
Frequency Response: (typical value)
(SPS eliminated)
100 W RMS: +0, -1 db, 20 Hz to 15 kHz
Total Harmonic Distortion:
300 kHz bandwidth measurement; AC powered
(100 W RMS, 70 volt and 25 volt lines)
20 Hz to 15 kHz, below 0.15% THD
Signal-To-Noise Ratio:
(unweighted, 20 Hz to 22 kHz; FCW attenuator setting)
S/N below 103 db
Slew Rate: (typical value)
10 V/
µ
s
Damping Factor: (typical value)
25 volt line; 1 kHz: 50
70 volt line; 1 kHz: 100
Input Impedance:
(FCW attenuator setting)
Balanced: 10 k ohms
Unbalanced: 10 k ohms
Input Sensitivity:
(FCW attenuator setting)
150 W RMS, rated output power
Input voltage: 1.1 V RMS
Voltage Gain:
dBV 27 db
Dimensions & Weight:
Height: 5.25" (13.3cm)
Width: 19" (48.3cm)
Depth: 13" (43.2cm)
Weight: 32 lbs.
Protection Systems:
Thermal shutdown 100
°
C
Current/Voltage limiting
Crowbar, on output to protect speakers from DC
Power Consumption:
Domestic model:
120 V AC, 60 Hz, 5 A, 600 W
24 V DC, 7 A
Export model:
230 V AC, 50 Hz, 2.6 A, 600 W
TM ®