Panasonic DMC-FT1 User Manual
Digital cameras
www.panasonic-europe.com
http://panasonic.net/lumix
DIGITAL CAMERAS
2009
About Waterproof / Dustproof performance of the camera “DMC-FT1”
This camera is waterproof / dustproof equivalent to “IP58”, and is possible to record at a maximum of 3.0 m depth/60 min. This does not guarantee non-
destruction, non-malfunction, and water-proofi ng in all conditions. Please observe specifi ed precautions and avoid product-use beyond the guaranteed
underwater duration, or beyond the guaranteed depth of water.
- Attention - To prevent water leakage, confirm that there is no foreign object near card/battery door then close door by pressing until it clicks. •
Use underwater up to 3.0 m depth and not longer than 60 minutes continuously. •Do not leave under low temperature in the cold climate, or where
the temperature is above 40°C for a long period of time. •When the unit is splashed with detergent, soap, hot spring, bath additive, sun oil, sunscreen,
chemical, etc., wipe it off immediately. •After use at the seaside or underwater, soak the unit in fresh water pooled in a shallow container for 10 minutes
or less. Do not leave uncared for more than 60 minutes after using underwater. It may cause deterioration of the waterproof performance. •Foreign
materials may be attached if the zoom lever or mode dial does not move smoothly. Soak the unit in fresh water, shake it well and then wash the zoom
lever and mode dial with tap water. •To maintain the waterproof performance, it is recommended that the waterproof seal (with fee) is replaced at least
once every 1 year at the retail store where you have bought the camera.
About Shockproof performance of the camera “DMC-FT1”
This camera has passed a drop test from 1.5 m in height in accordance with “MIL-STD 810F Method 516.5-Shock”, but this does not guarantee non-destruction,
non-malfunction, and water-proofi ng in all conditions. Water-proofi ng is not guaranteed if the unit is subject to an impact as a result of being hit or dropped etc.
- Drop Test – Test standard: MIL-STD 810F Method 516.5-Shock •Drop height: 1.5m •Drop surface: 5cm thick plywood •Number of units tested: 5 •Drop
orientations: 26 (each face, edge and corner) •Number of drops: 1 (for each orientation) •Unit inspected after each drop and found to be operating within
product specifi cations. Change of appearance - paint-loss or deformation not measured.
•PHOTOfunSTUDIO: Requires Microsoft® Windows® 2000/XP or Vista®. •SILKYPIX® Developer Studio: Requires Microsoft® Windows® 2000/XP or
Vista® (Only a systems administrator with authority can install software on a Windows® XP or 2000), or Apple® Mac OS® X v10.2 or later (Version 10.3
or later is recommended). •ArcSoft® MediaImpression™, Panorama Maker™: Require Microsoft® Windows® 2000/XP/Vista®, or Apple® Mac OS
® v10.3 or newer (Version 10.4 or later is recommended). •Weight and dimensions shown are approximate. •Design, functions, and specifi cations are
subject to change without notice. •Some sample images are simulated. •Some accessories are not available in some countries. •The use of recorded or
printed materials that are protected by copyright for any purpose other than personal enjoyment is prohibited, as it would infringe upon the rights of the
copyright holder. •AVCHD Lite motion images recorded onto an SD Memory Card or a DVD disc cannot be played from a device that does not support the
AVCHD standard. •The “AVCHD Lite” and “AVCHD Lite” logos are trademarks of Panasonic Corporation and Sony Corporation. AVCHD is a high-defi nition
(HD) digital video recording / playback format jointly established by Panasonic Corporation and Sony Corporation. AVCHD Lite is a subset of the AVCHD
format for HD digital video cameras with HD video recording restricted to 720P. The new “AVCHD Lite” logo and the “AVCHD Lite” license are restricted to
devices within the AVCHD Video Camera category. Digital cameras have been added to the AVCHD Video Camera category. For more details, please refer
to the “AVCHD Information Website”. http://www.avchd-info.org/ •Leica is a registered trademark of Leica Microsystems IR GmbH. •The LEICA DC VARIO-
ELMARIT, VARIO-ELMAR, and VARIO-SUMMICRON lenses are manufactured using measurement instruments and quality assurance systems that have
been certifi ed by Leica Camera AG based on the company’s quality standards. •YouTube is a trademark of Google Inc. •Dolby and the double-D symbol
are trademarks of Dolby Laboratories. •HDMI, the HDMI logo and High-Defi nition Multimedia Interface are trademarks or registered trademarks of HDMI
Licensing LLC. •Microsoft® and Windows® are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other
countries. •Apple® and Mac OS® are either registered trademarks or trademarks of Apple, Inc. in the United States and/or other countries. •QuickTime
and the QuickTime logo are trademarks or registered trademarks of Apple, Inc., used under license therefrom. •Other names of systems and products
mentioned in this brochure are generally the registered trademarks or trademarks of the manufacturers who developed the system or product concerned.
.
About the performance of Face Recognition function
Recognition performance varies greatly depending on shooting conditions, i.e., according to factors such as angles, facial expression and lighting, so
operation under all conditions cannot be guaranteed. Because the camera searches for faces that are similar to registered faces, there are cases where
the faces are not correctly recognized when the registered image and the shooting image varies much. When facial characteristics are similar, particularly
between parents and their children or brothers and sisters, the camera may not distinguish the faces.
Eu
ro
pe
V
er
si
on
. P
AG
E. 01
-4
0 2
00
9.
1.
28 N
on A
ss
oc
ia
te
s