Indicators, Typical applications – Powerware 5110 User Manual
Page 7
User’s manual
350 - 1500 VA
7
1023922
Revision A
Typical applications
Indicators
1. On/Off/Test Switch
One switch controls power to your equipment and performs a self-test to detect
overload/undercharge.
Turn on the UPS.
Press and hold the switch for more than one second and release the switch after the
beep. The UPS will start.
Turn off the UPS.
Press and hold the switch for more than one second and release the switch. The UPS
will shut down completely.
Perform Self-test.
The UPS will perform self-test for about 4.5 seconds when the UPS is turned on and
the utility power is present.
See also other documents in the category Powerware Tools:
- UPS 1000 - 2200 (24 pages)
- 9 (70 pages)
- 9155 UPS20-30kVA (52 pages)
- 8 - 15 kVA (46 pages)
- 9125 Two-in-One UPS 5000 (66 pages)
- Model V-2000B (137 pages)
- 9335 (100 pages)
- 9120 (5 pages)
- 5115RM (24 pages)
- P93 (6 pages)
- 9390 UPS 100160 kVA (216 pages)
- Horsepower Computer System ST-2400S (17 pages)
- 9155 (10 pages)
- 9125 Two-in-One UPS 2500 (78 pages)
- 5075 kVA (162 pages)
- 380/220V (72 pages)
- 30-160kVA (48 pages)
- Ferrups FE/QFE 500VA (76 pages)
- FSS-0342J (44 pages)
- 9395 UPS and Plus 1 UPS 650825 kVA (192 pages)
- 9315s (205 pages)
- Ferrups FE/QFE UPS (72 pages)
- 9315 UPS (84 pages)
- 5140 (68 pages)
- 9330 (246 pages)
- 9355 (62 pages)
- BladeUPS none (32 pages)
- 5115A USB (44 pages)
- 9170+ (94 pages)
- 9170+ (12 pages)
- 9910 p Series (6 pages)
- 9125 (30 pages)
- 4500 (92 pages)
- 9395 (4 pages)
- X-Slot USB Module (10 pages)
- 9150 (64 pages)
- 5105 (4 pages)