ProForm PFEL71031 - Manual (Page 9)

9
12. The Console (5) requires four “D” batteries (not includ-
ed); alkaline batteries are recommended. Press the
indicated tab on the battery drawer and pull the bat-
tery drawer down. Press four batteries into the battery
clips;
make sure that the batteries are oriented as
shown by the markings inside of the battery clips.
Then, close the battery drawer.
Note: The Console (5) can be operated with an optional
power supply instead of batteries.
To order a power
supply, call toll-free 1-888-533-1333. Plug one end
of the power supply into the jack at the rear of the
elliptical crosstrainer (see the inset drawing). Plug the
other end of the power supply into an appropriate out-
let that is properly installed in accordance with all local
codes and ordinances.
13. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may
be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical crosstrainer.
11. Attach the Left Handlebar Cover (109) to the Console
(5) with three M4 x 16mm Screws (66). Do not over-
tighten the Screws; overtightening the Screws may
cause the Console to malfunction. Attach the Right
Handlebar Cover (110) in the same way.
11
5
66
66
109
110
Batteries
Battery
Drawer
5
Tab
Power
Supply
Power
Jack
12