Philips AX 2300 - Manual (Page 2)

English CONTROLS / POWER SUPPLY
1 OPEN 2 ..............opens the CD lid
2 ∞ .......................skips and searches CD tracks backwards
3 § .......................skips and searches CD tracks forwards
4 DBB.....................switches the bass enhancement on and off. This button also
switches acoustic feedback (the beep) on/off when it is
pressed for more than 2 seconds
5 PROG...................programs tracks and reviews the program
6 ............................display
7 MODE .................selects the different playing possibilities:
SHUFFLE ,
SHUFFLE REPEAT ALL , REPEAT , REPEAT ALL and SCAN
8 9.........................stops CD play, clears a program or switches the player off
9 2; ......................switches the player on, starts or pauses CD play
0 RESUME .............stores the last position of a CD track played
HOLD...................locks all buttons
OFF......................switches RESUME and HOLD off
! LINE OUT/p........3.5 mm headphone socket, socket to connect the player to
another audio input of an additional appliance.
@ VOL E ............adjusts the volume
# 4.5V DC...............socket for external power supply
$ ............................type plate
CAUTION
Use of controls or adjustments or performance of procedures other than
herein may result in hazardous radiation exposure.
POWER SUPPLY / GENERAL INFORMATION
Use only the AY 3170 adapter (4.5 V / 300 mA direct current, positive pole to the
center pin). Any other product may damage the player.
1 Make sure the local voltage corresponds to the power
adapter’s voltage.
2 Connect the power adapter to the 4.5V DC socket of
the player and to the wall socket.
Note: Always disconnect the adapter when you are not
using it.
Environmental information
• All redundant packing material has been omitted. We have done our utmost to
make the packaging easily separable into two materials: cardboard (box) and
polyethylene (bags, protective foam sheet).
• Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packing materials, exhausted batteries and old equipment.
C LASER P
This product complies with the radio interference requirements of the
European Union.
Batteries (supplied or optionally available)
You can use the following batteries with this CD-player:
• normal batteries type LR6, UM3 or AA (preferably Philips), or
• alkaline batteries type LR6, UM3 or AA (preferably Philips).
Notes:– Old and new or different types of batteries should not be combined.
– Remove batteries if they are empty or if the player is not going to be used for
a long time.
Inserting batteries
1 Push OPEN
2 to open the CD lid.
2 Open the battery compartment and insert either 2
normal or alkaline batteries.
Battery indication
The approximate power level of your batteries is shown
in the display.
Battery full
Battery two-thirds full
Battery one-third full
Battery dead or empty.When the batteries are
dead or empty, the symbol
A flashes,
bAtt is displayed, and the beep tone sounds repeatedly.
Batteries contain chemical substances, so they should be disposed
of properly.
• Do not touch the lens A of the CD player.
• Do not expose the unit, batteries or CDs to humidity,
rain, sand or excessive heat (caused by heating
equipment or direct sunlight).
• You can clean the CD player with a soft, slightly
dampened, lint-free cloth. Do not use any cleaning
agents as they may have a corrosive effect.
• To clean the CD, wipe it in a straight line from the
center toward the edge using a soft, lint-free cloth. A
cleaning agent may damage the disc! Never write on a CD or attach a sticker
to it.
• The lens may cloud over when the unit is moved suddenly from cold to warm
surroundings. Playing a CD is not possible then. Leave the CD player in a warm
environment until the moisture has evaporated.
• Active mobile phones in the vicinity of the CD player may cause malfunctions.
• Avoid dropping the unit as this may cause damage.
Headphones HE 035
• Connect the supplied headphones to the LINE OUT/p
jack of the player.
Note: LINE OUT/p can also be used for
connecting this set to your HiFi system.To adjust
the sound and volume, use the controls on the
connected audio equipment and on the CD player.
IMPORTANT!
Hearing safety: Do not play your headphones at a high volume. Hearing experts advise
that continuous use at high volume can permanently damage your hearing.
Traffic safety: Do not use headphones while driving a vehicle. It may create a hazard
and it is illegal in many countries. Even if your headphones are an open-air type
designed to let you hear outside sounds, do not turn up the volume so high that you
cannot hear what is going on around you.
VO L
E
O FF • R S U M E • H O LD
O U T
LIN E /
CD player and CD handling