Philips SE455C - Manual (Page 46)

44 The System
15 The System
15.1 Registering handset(s)
The procedures described below are the
procedures you will find in your handset.
The procedures may vary according to
the handset you want to register. In this
case, refer to the manufacturer's
instruction of the additional handset.
Additional handsets must be registered to
the base station before you can use them.
Your base station can register up to 5
handsets.
Press
m
on the handset you want
to register.
Select
ADVANCED SET >
REGISTER . Press OK .
Follow the handset's screen
instruction.
• Registration shall be completed in
less than 2 minutes. The base
automatically assigns a handset
number to the handset.
Note
If no base is found within a certain period,
your handset displays a notification
message. Repeat the above procedure if
registration failed.
15.2 Un-registering a handset
Use one handset to unregister another
handset that shares the same base station.
Press
m
.
Select ADVANCED SET >
UNREGISTER . Press OK .
Select the handset (number) you
want to un-register.
Tip
Handset Number. The handset number
displays beside the handset name during
standby.
Press OK .
• The handset is un-registered.
15.3 Changing your PIN
The system PIN is used for protecting
access rights to some of the menus and
remote access. The pre-set PIN is 0000.
You can personalize your PIN for greater
security.
Press
m
.
Select ADVANCED SET > CHANGE
PIN . Press OK .
Enter the current system PIN. Use
BACK to make corrections. Press
OK to confirm the system PIN.
Enter the new system PIN. Press
OK .
Enter the new system PIN again for
verification. Press
OK .
• The setting is saved.
Note
Forgotten PIN. Write down your PIN and
save it for future use. If you have
forgotten the PIN, reset your phone and
your PIN code will be restored to the
factory pre-set PIN (0000). To reset your
phone, see “Restoring default settings”
on page 44.
15.4 Restoring default settings
You can reset your phone settings to the
original factory settings.
Press
m
.
Select ADVANCED SET > RESET .
Press OK .
1
2
3
1
2
3
5
1
2
3
4
5
1
2