Philips AZ 1145 - Manual (Page 11)

English
DIGITAL TUNER
11
TUNING TO RADIO STATIONS
1. Select TUNER source.
™
is displayed briefly and then the radio station
frequency is shown.
2. Press BAND once or more to select your waveband.
3. Press
∞ or § on the set or on the remote control and release
when the frequency in the display starts running.
™ The tuner automatically tunes to a station of sufficient
reception. Display shows during automatic tuning.
™ If an FM station is received in stereo,
STEREO is shown.
4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press
∞ or § briefly and
repeatedly until you have found optimal reception.
5. Adjust the power slider to TAPE/
OFF
position to switch off the
set.
To improve radio reception
– For FM, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
– For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
Favorite station selection
For your favorite 3 tuner stations, you can use the easy one-touch
programming and selection 1, 2 or 3 buttons.
1. Tune to your desired station (see Tuning to radio stations).
2. To store your station, press 1, 2 or 3 for 2 seconds or more.
™ Display: shows
PROGRAM briefly, your favorite preset station
number and the tuner frequency.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROGRAM to activate programming.
– Display:
PROGRAM
flashes.
3. Press PRESET
4 or 3 once or more to allocate a number from
1 to 30 to this station.
4. Press PROGRAM again to confirm the setting.
– Display:
PROGRAM
disappears, the preset number and the
frequency of the preset station are shown.
5. Repeat the above four steps to store other stations.
– You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press 1, 2, 3 or PRESET
4 or 3 until the desired preset station is
displayed.
AZ 1145 /17
page
11
PROGRAM
REPEAT ALL
CD
SEARCH
STOP•O PEN
SEARC H
PLAY RECOR D
1 2 3
BA ND PRESET
PROGRAM
REMOTE
SENSOR
M
T
D
SEARCH
SEARC H
PLAY RECOR D
1 2 3
BAND PRESET
PROGRAM
REMOTE SENSOR
GRAM
PEAT ALL
CD
SEARCH
PEN
SEARCH
PLAY
RECOR D
1 2 3
BAN D PRESET
PROGRAM
REMOTE
SENSOR
FM
TUNER
STEREO
XP AZ 1145/17 02-02-2000 11:56 Pagina 11