Philips AJ 3941 - Manual (Page 8)

INSTALLATION
8
English Power breakdown
In the event of a power failure the set will be completely
switched off. Disconnect the set first and re-plug after
3 seconds or more. Most of the settings will remain in the
memory, but you will need to reset the time and day on the
clock.
To retain the clock time and the set alarm time(s) in the event of
an AC power failure or disconnection, insert 3x AA/L6/UM3
batteries (not supplied) into the the battery compartment:
this will act as a power backup. However, the time will not be
illuminated on the clock display. Operation of the alarms, CD
player and radio are also excluded. For clarity, the battery
backup is used to retain the set clock and alarm time(s)
only. As soon as the power supply returns, the set will resume
the standby mode and the display will indicate the correct time.
1. Connect the power plug to the wall outlet.
2. Insert the batteries into the battery compartment
• Replace the batteries at least once a year to prevent battery
leakage, or as often as necessary according to power
breakdown usage.
Batteries contain chemical substances, so they should
be disposed of properly
Connecting headphones / loudspeakers
Connect headphones / active loudspeakers with a 3.5 mm plug
into the p jack.
™ The built-in loudspeakers of the set will now be muted.
Illumination brightness
Press BRIGHTNESS once or more to change the brightness of
the display.
™The brightness of the display will change in this sequence:
LOW ™ MEDIUM ™ BRIGHT ™ LOW....
Clock display
The time is displayed using the 12 hour clock with AM/PM
indicators.
XP AJ 3940/3941/17.1 29-03-2001 10:57 Pagina 8