POSIFLEX Business Machines AURA 6800 - Manual (Page 13)

Page 13
release button is pressed. Should the cutter jam be so serious to interfere the
hood release operation, please re-close the hood and try opening it again.
Never force open the top hood. Please also clear away any contaminants
accumulated in the cutter track above the thermal elements.
Advanced Analysis Tool
This printer supports Hexadecimal Dump for experienced user to view
exactly what data the printer receives. This can be useful in finding software
problems.
To start the dump mode: Turn off printer; Open print hood; Hold down FEED
button while turning printer on; Close the hood.
To stop the dump mode: Press the FEED button to print out the last line; Turn
off the printer.
During dump mode: All commands except DLE EOT and DLE ENQ are
disabled.
USEFUL TIPS
* Please note that only those qualified technicians may adjust several
jumpers for some technical settings. Please visit our web site
http://www.posiflex.com or http://www.posiflex.com.tw for details of the
technical information such as driver installation, DIP switch settings and
command sets etc. if required.
* Place the printer on a sturdy, level surface.
* Choose a place that is well ventilated and free of excessive dust, smoke or
fume.
* Do not put the printer under direct sunlight or near a heater.
* Ideal room temperature is from 5ºC to 40ºC. Ideal humidity is from 20% to
85% RH (no condensation).
* Do not set any liquid or drinks such as coffee on the printer case.
* Do not touch any metal part to avoid possible electrostatic damage.
Auto Cutter Track
Thermal Elements