Poulan BC2400P - Manual (Page 6)

6
S Place the metal shield under the gearbox,
and align the screw holes.
Shield Gearbox
S Insert and thread the 4 mounting screws
through the holes of the gearbox and the
metal shield. Tighten evenly and securely
with the hex wrench provided.
INSTALLATION OF THE METAL
BLADE
WARNING: Do not use any blades, or
fastening hardware other than the washers and
nuts shown in the following illustrations. These
parts must be provided by Poulan/Weed Eater,
and installed as shown below. Failure to use
proper parts can cause the blade to fly off and
seriously hurt you or others.
NOTE: The dust cup is located on the gearbox
and not in the parts bag. All other fastening
hardware mentioned in the following assembly
steps is located in the parts bag.
S
Leave the dust cup on the gearbox.
S Install the blade and the retaining washer
over the threaded shaft extending from the
gearbox. NOTE: It may be necessary to
remove a plastic protective covering from
the threaded shaft before installing these
parts.
S Make sure the raised part of the retaining
washer is facing the gearbox and the raised
area fits into the hole in the center of the
blade (see illustration).
S Slide the blade and retaining washer onto
the shaft of the gearbox.
S Now place the cupped washer onto the
shaft. Make sure the cupped side of the
washer is toward the blade.
S Install the blade nut by threading onto the
shaft counterclockwise.
Shield
Blade
Retaining
Washer
Dust Cup
Cupped
Washer
Nut
Threaded Shaft
NOTE: Make sure all parts are in place as illus-
trated, and the blade is sandwiched between
the dust cup and the retaining washer. There
should be no space between the blade and the
dust cup or the retaining washer.
S
Push in locking lever and hold.
S Rotate blade nut until the locking lever falls
into one of the grooves in the dust cup.
Locking Lever
S Continue to hold in locking lever. This will
keep the shaft from turning while tightening
the blade nut.
S Tighten blade nut firmly with a wrench.
S Release locking lever.
S Turn blade by hand. If the blade binds
against the shield, or appears to be uneven,
the blade is not centered, and you must re-
install.
FUEL YOUR UNIT
WARNING: Remove fuel cap slowly
when refueling.
This engine is certified to operate on unleaded
gasoline. Gasoline must be mixed with a good
quality 2-cycle air-cooled engine oil designed to
be mixed at a ratio of 40:1. Poulan/Weed Eater
brand oil is recommended. (A 40:1 ratio is ob-
tained by mixing 3.2 ounces of oil with 1 gallon of
unleaded gasoline). When mixing fuel follow the
instructions printed on the container. Always
read and follow the safety rules under FUEL
SAFETY.