Philips VR750/58 - Manual (Page 5)

5 EN
Then, read the section 'Preparation for use' in
the chapter 'Installing your video recorder'.
Connecting without a scart cable
Have an aerial cable ready (supplied).
1. 1. Switch off your TV.
2. 2. Remove the aerial cable plug
from the aerial input socket of
the TV. Insert it into the AERI-
AL at the back of the
video recorder.
3. 3. Insert one end of the
supplied aerial cable
into the RF OUT at
the back of the video
recorder and the
other end into the
aerial input socket at
the back of the TV.
4. 4. Insert AC cable into
the wall socket.
5. 5. Switch on your TV and select the programme
number used for video playback on your TV
(see your TV’s operating instructions).
6. 6. Start the TV’s channel search manually as if
you wanted to save a new TV channel until
the next screen appears (see your TV’s oper-
ating instructions).
7. 7. Save this programme number setting on your
TV for video recorder operation.
Then, read the section 'Preparation for use' in
the chapter 'Installing your video recorder'.
Audio output Connection
Prepare an audio cable (not supplied).
1. 1. Switch off your audio amplifier.
2. 2. Insert one end of the audio cable into the cor-
responding red and
white AUDIO OUT-
PUT L/R socket at
the back of the video
recorder and the
other end into the
corresponding audio input socket at the audio
amplifier.
Connecting additional devices
You can connect additional devices such as
decoders, satellite receivers, camcorders, etc. to
the socket AV2(DECODER).
My screen is empty
• Many TVs are switched to the programme
number for the scart socket by way of a con-
trol signal sent through the scart cable.
• If the TV does not automatically switch to the
scart socket programme number, manually
change to the corresponding programme num-
ber on your TV (see your TV’s operating
instructions).
RF OUT
AV 1 (TV)
AERIAL
AUDIO OUTPUT L
R
RF OUT
RF OUT
AV 1 (TV)
AERIAL
AUDIO OUTPUT L
R
AERIAL
I do not see a Language setting picture
• Check the cable connections.
• Repeat the channel search on your TV.
Programme number for video recorder oper-
ation
You have now saved a programme number for
use by your video recorder as you would a reg-
ular TV channel. This programme number must
now be used in future for video recorder play-
back (video recorder TV channel).
RF OUT
AV 2 (DECODER)
AV 1 (TV)
AERIAL
AUDIO OUTPUT L
R RF OUT
AV 2 (D ECODE R) AV 1 (T V)
AERIAL
AUDIO OUTPUT L
R
AV2(DECODER)
RF OUT
1 (TV)
AERIAL
AUDIO OUTPUT L
R
PUSH MENU TO CONTINUE
Programme numbers of 'AV2' scart socket
and FRONT A/V CONNECTORS
If you are using the scart socket AV2 (DECODER),
select programme number
' AV2 ' with 0.0.2.
If you are using the FRONT A/V CONNECTORS,
select programme number
'AV3' with 0.0.3.
HG494/498ED.qx3 03.12.22 9:52 PM Page 5