Philips Super Parquet Nozzle FC8042 - Manual (Page 4)

Super Parquet nozzle
This nozzle enables you to clean and polish your hard floor. It removes
3 times more dirt.
Never use water to clean wooden floors or parquet.
To clean the Super Parquet nozzle:
1 You can remove the pads by pulling them off the discs (the pads
are fastened to the discs by means of Velcro).
2 You can clean the pads by removing the Super Parquet nozzle
from the appliance and vacuum cleaning the pads while still
attached to the nozzle. Select the lowest suction power setting.
◗ You can also clean the pads in warm water (with some soap).
◗ The pads can even be washed in the washing machine.
Wash the pads seperately. ( & * ^
Never use chloride or fabric softener to clean the pads.
Make sure the pads are clean and dry before you use them again.
3 Reattach the red sides of the clean pads to the discs.
The light blue sides of the pads need to be in contact with the floor, not
the red sides!
Replace the pads at least every three months.
New pads are available from your local Philips dealer (type HR8041).
ENGLISH 4