Philips CCA092AT - Manual (Page 47)

Specifications
General
CRT: 9-inch in line gun
Television system: NTSC-M
Video Heads: Two heads
Tape width: 1/2 inch (12.65 mm)
Tape speed
SP: 33.35 mm/sec.
LP: 16.67 mm/sec.
SLP: 11.12 mm/sec.
Operating Temperature: 41˚F (5˚C) to 104˚F (40˚C)
Relative Humidity: 10% to 75%
Power requirement: AC 120V/DC 13.2V, 60Hz
Power consumption: 65W (AC/DC)
Sound output: 0.8W
Dimensions:
13" (H) x 12-1/8" (W) x 13" (D)
330mm x 308mm x 330mm
Weight: 18.8 lbs (8.5 kg)
Tuner Broadcast Channels
VHF 2-13, UHF 14-69
Cable TV Channels
Midband: A – 1
Superband: J – W
Hyperband: A-5 – A-1
Special Channel: 5A
Ultraband: 37 – 94, 100 – 125
Terminals
Antenna In: VHF/UHF 75 ohms unbalanced
Video In: RCA connector
Audio In: RCA connector
Earphone: 3.5 mm CES
Electrical Specifications
Video input level: 0.5~2.0Vp-p
Audio input level: -10dBv
Video S/N ratio
SP: More than 42dBµ
Audio S/N ratio
SP: More than 38dB
Designs and specifications are subject to change without
notice and without our legal obligation.
Glossary
AUDIO Jack: jack located on the front of the
TV/VCR which is used to record audio from anoth-
er source.
Automatic Channel Setup: process in which the
TV/VCR scans all available channels and places the
ones you receive in its memory. Then, when you
push the CHANNEL o/p buttons, you only scan
through channels you receive.
Bands: settings that allow you to tune channels.
• Antenna – VHF (very high frequency; channels
2-13) and UHF (ultra high frequency; channels
14-69).
• Cable – all standard channels can be received
without a Cable Box.
Brightness: adjusting increases or decreases the
brightness of the color on the screen.
Color: adjusting pales or brightens the TV/VCR
color.
Dubbing: copying a tape using a VCR.
HQ: high quality; a feature in the TV/VCR circuitry
which provides enhanced picture detail.
Line Input: The channel to which you set your
TV/VCR during dubbing. The line input channel is
always channel 00 (A/V IN).
Mode: a TV/VCR operation.
OTR: One-Touch Recording; a timed recording
that starts immediately and records for 30 minutes
to eight hours, whichever you specify.
Picture: adjusting increases or decreases the con-
trast of the picture on the screen.
Sharpness: adjusting softens or clarifies the picture
on the screen.
Tape Speeds: how fast the tape travels during
playback or recording.
• SP (standard play) – fastest tape speed (record-
ing time for a T120 tape is approximately two
hours); best picture quality.
• LP (long play) – average tape speed; playback
only.
• SLP (super long play) – slowest tape speed
(recording time for a T120 tape is approximately
six hours).
Tint: adjusting changes the tints of the picture on the
TV/VCR from purple to green.
VIDEO Jack: jack located on the front of the
TV/VCR which is used to record video from anoth-
er source.
Specifications/Glossary 47