PYLE Audio PLCDCS330MP - Manual (Page 14)

14
Before going through the check list, check wiring connection. If any of the problems
persist after check list has been made, consult your nearest service dealer.
Symptom Cause Solution
No power. The car ignition switch is If the power supply is
not on. connected to the car accessory
circuits, but the engine is not moving,
switch the ignition key to “ACC”.
The fuse is blown. Replace the fuse.
Disc cannot Presence of CD disc inside Remove the disc in the player, then
be loaded or the player. put a new one.
ejected.
Inserting the disc in Insert the compact disc with the
reverse direction. label facing upward.
Compact disc is extremely Clean the disc or try to play a new
dirty or defective disc. one.
Temperature inside the car Cool off or until the ambient
is too high. temperature return to normal.
Condensation. Leave the player off for an hour or
so, then try again.
Cassette tape Presence of a cassette Remove the cassette tape in the
cannot be tape in the player. player, then put in the new one.
loaded or
ejected.
The temperature in the car Cool off the inside of the car, then try
is too high. again.
Condensation. Leave the cassette player off for an
hour or so, then try again.
No sound. Volume is in minimum. Adjust volume to a desired level.
Wiring is not properly connected. Check wiring connection.
Sound skips The installation angle is Adjust the installation angle to less
or sound more than 30 degrees. than 30 degrees.
quality is poor.
The disc is extremely dirty Clean the compact disc, then try to
or defective disc. play a new one.
The cassette is defective. Try another cassette.
The operation The built-in microcomputer Press the RESET button.
keys do not is not operating properly Front panel is not properly fixed into
work. due to noise. its place.
The radio does The antenna cable is not Insert the antenna cable firmly.
not work. The connected.
radio station
automatic
The signals are too weak. Select a station manually.
selection does
not work.
TROUBLE SHOOTING