No signal menu – Polaroid SVGA 270 User Manual

Page 16

1-15

TIIO

S ((cco

nttiin

ueed

d))

ENGLISH

No Signal Menu

The same adjustments and settings are available as with the Image and
Options menus when the MENUO button is pressed during display of the
‘NO INPUT IS DETECTED ON ***’ or ‘SYNC IS OUT OF RANGE
ON ***’ message while no signal is received. See Table 1.7 below.

Table 1.7 No Signal Menu

VOLUME

KEYSTONE

BLANK

MIRROR

START UP

MENU COLOR

TIMER

LANGUAGE

AUTO OFF

SYNC ON G

40
+1

Item

Description

VOLUME

Volume adjustment:

Reduce VOLUME

↔

Increase VOLUME

KEYSTONE

Adjustment:

Reduce size of bottom of image

↔

Reduce size of top of image

BLANK

Select blank screen color:

Select color with the

and

buttons.

* The image is cleared when the BLANK MODE is set with BLANK ON,

or when there is no signal, and the entire screen is displayed in the
selected color. Note that if TURN OFF is selected on the START UP
the blank screen is displayed in blue when there is no signal.

MIRROR

Operation start/stop:

Press

the or button.

Select Mirror status:

Select mirror status with

and

buttons.

START UP

Operation start/stop:

Press the

button.

Setup initial screen display:

Select TURN ON with the

button.

Clear initial screen display:

Select TURN OFF with the

button.

* Note that if TURN OFF is selected the blank screen is displayed in

blue when there is no signal.

MENU COLOR

Select menu background color:

Select with the

and

buttons.

TIMER

Operation start/stop:

Press

the or button.

Setup initial timer value:

Set 1~99 minutes with the

and

buttons.

LANGUAGE

Operation start/stop:

Press

the or button.

Select menu display language:

Select with the

and

buttons.

AUTO OFF

Operation start/stop:

Press

the or button.

Set AUTO OFF:

Set 0~99 minutes with the

and

buttons.

The system automatically enters the standby mode when a signal is
not received for the set time.

Clear AUTO OFF:

Select STOP (0 min.) with the

button.

Wind Stop is selected the system does not enter the standby mode
even if no signal is received.

SYNC ON G

Operation start/stop:

Press

the or button.

SYNC ON G valid:

Select TURN ON with the

button.

SYNC ON G invalid:

Select TURN OFF with the

button.

* When SYNC ON G is effective, it may not be displayed normally by an input

signal. Remove a signal connector, and make it condition without a signal, and
input a signal again in this case SYNC ON G after it is overridden.