Powermatic PM1300 - Manual (Page 10)

10
Filter Bag System Assembly
Note: If your dust collection system includes the
canister kit, proceed to Canister System
Assembly on page 11.
1. Insert a hanger bracket between support bar
and collector housing (Figure 4).
2. Align holes and secure with two M8x20 hex
cap screws and two M8 flat washers outside
the housing, and two M8 flat washers and
two M8 hex nuts inside the housing. Hand
tighten only.
Figure 4
3. Make any needed adjustments to the
support bar, then tighten the two upper and
two lower screws on the support bar with a
13mm wrench.
4. Slide the hanger (Figure 4) onto the hanger
bracket as far down as it will go. Rotate the
hanger so that the hook at the top points
toward the front of the machine.
5. Insert the ring (Figure 5) of the collector bag
into the bottom of the housing at an angle.
Pull down on the collector bag to make sure
it “seats” on the inner lip of the housing.
6. Position the plastic window in front so that
you can easily see when collector bag is full.
7. Slide the top loop of the filter bag onto the
hanger hook (Figure 6).
8. Thread the retainer strap (Figure 6) through
the loops on the filter bag, and fasten it to
the collector housing, as shown in Figure 7.
The retainer strap should be tight enough to
provide a good seal.
Figure 5
Figure 6
Figure 7
Retainer strap
connection