Philips AZ1123WCD - Manual (Page 6)

Power Supply General Operation/Tuner
Using AC power
WARNING: Always check you have
completely switched off the set, before
you change or disconnect power supply.
1 Check if the power voltage, as shown on
the type plate located on the
bottom of the set,
corresponds to your
local power supply. If it does not, consult your
dealer or service center.
2 Connect the power cord to the AC
MAINS~
inlet and the wall socket.The set is
now connected and ready for use.
3 To switch the set off completely, withdraw the
power cord from the wall socket.
4 Install the unit near the AC outlet and where
the AC power plug can be easily reached.
• Disconnect the power cord from the wall
socket to protect your set during heavy thun-
derstorms.
Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.
The type plate is located on the
bottom of the set.
Helpful hints:
– To avoid unnecessary energy consumption,
always adjust the Source selector to
OFF
after using the set.
General operation
Switching on and off and selecting the
function
1 To select your sound source, adjust the
Source selector
to: CD, FM or MW.
2 To switch off the set, adjust the Source
selector
to OFF position
Adjusting volume
Adjust the sound with the VOLUME con-
trols.
Radio reception
1 Adjust the Source selector to FM or
MW
to select your desired
waveband.
2 Turn TUNING to tune to a station.
Helpful hints:
To improve radio reception
• For FM, extend, incline and turn the telescop-
ic antenna for best reception. Reduce its
length if the signal is too strong.
• For MW, the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
AZ1123_A 2007.7.27 17:42 Page 6