Start your installation – Planar PX1710M User Manual
Page 8
6
English
u
Connecting the Display
(Figure 7.1)
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the DC power cord to the power connector; plug one end
of the AC power cord into the power adapter, and then the other
end into an electrical outlet().
3. For the PC with Analog output: Connect the VGA signal cable from
display VGA input connector to the 15-pin connector of your host
computer and tighten the screws().
For the PC with DVI digital output: Connect the DVI signal cable to
the connector of the display card in your computer; connect the
other side to the DVI-D input port of your display. Tighten the
screws( ).
5.
Turn on your computer, display and video source.
Start Your Installation
Notice: To ensure the LCD display can work well with your computer, please
configure the display mode of your graphic card to make it less than or
equal to 1280 x 1024 resolution and make sure timing
of
the display mode
is
compatible
with the LCD display. We have listed the Compatibility
Modes
of
this LCD display
in
appendices for your reference.
Connect the Audio-In cable from the audio input port of your display to the
Audio-out port of your computer
4.
).
(
.
6