Pioneer BR-SXT01 - Manual (Page 31)

31
Suggested for AppleTalk
The settings above are all that is generally required for AppleTalk operation over
Frame Relay.
DECnet Protocol
Required for DECnet
WAN interfaces which are set for Frame Relay operation do not need any additional
parameters set in order to function.
Link Configuration
Frame Relay is presently supported in the BR Router only via synchronous
dedicated line operation.
• Set interface for Synchronous operation
• Set Dedicated connection
• Set Frame Relay connection
RV: Use the WAN/Link screen.
CL: Use interface(misc), wan serial(set), and wan connect(set).
Suggested for Dedicated/Leased Line Operation
Dedicated line operation generally does not require additional parameters for
operation.
Frame Relay DLCI Mappings
If you are connecting to another DCB router, this information is not required for
Frame Relay operation. DCB uses IARP (Inverse Address Resolution Protocol) to
dynamically generate this information. To connect to other vendors’ routers which
do not support IARP, you must provide DLCI to protocol mapping information.
v
Note : Many Internet Service Providers (ISP’s) do not support IARP as a default.
If one of your BR Router interfaces will be connected to an ISP via Frame Relay,
check with your ISP technical staff on whether you must manually enter DLCI
information or not.
RV: Use the DLCI Mapping Database window.
CL: Use interface(misc) and then frelay(set).