Plinius Audio M8 User Manual

Page 11

PLACEMENT AND VENTILATION

ACEMENT AND VENTILATION

Ventilation through and around your Plinius M8 Preamplifier should be kept unimpeded, so ensure that
the heat vents (slots in the lid and base) are not covered or restricted in any way.

The Plinius M8 design incorporates a very high level of mechanical de-coupling of the input and output.
However, it can still be influenced by acoustical feedback in the operating environment. The use of
acoustic cones or a suitably spiked preamplifier stand or table, may further enhance the performance of
this preamplifier. Consult your PLINIUS

PLINIUS

PLINIUS dealer for further advice if required.

MAIN

MAINS VOLTAGE CONNECTION

S VOLTAGE CONNECTION

Firstly, check that the mains supply voltage printed on the rear of this preamplifier is similar to the mains
supply voltage in your area. If in doubt, please consult your PLINIUS

PLINIUS

PLINIUS dealer.

Mains supply power connection is via the supplied plug-in lead. A standard IEC socket connects the
mains power at the preamplifier end, while a local mains plug is required at the wall end.

The wiring code used inside all Plinius product is:

Green to Earth/Ground

Green to Earth/Ground
Blue to Neutral

Blue to Neutral

Blue to Neutral
Brown to Phase/Live

Brown to Phase/Live

Should a ‘local’ plug need fitting to the wall end of the lead, ensure that a suitably qualified service
technician wires the plug correctly.

IMPORTANT

IMPORTANT: : : :

DO NOT POWER UP Y

DO NOT POWER UP YOUR PREAMPLIFIER UNTIL YOU

OUR PREAMPLIFIER UNTIL YOU

OUR PREAMPLIFIER UNTIL YOU HAVE

HAVE

CONNECTED YOUR INPUT/OUTPUT

CONNECTED YOUR INPUT/OUTPUTS CORRECTLY FOR YOUR

S CORRECTLY FOR YOUR

SYSTEM, (AS EXPLAI

SYSTEM, (AS EXPLAINED IN THE NEXT SECTION).

NED IN THE NEXT SECTION).