Philips SOUNDMACHINE AZ382 - Manual (Page 10)

Problem
– Possible cause
• Remedy
No sound /power
– Volume not adjusted
• Adjust the
VOLUME
– Power cord not securely connected
• Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
– CD contains non-audio files
• Press
∞ , § once or more to skip to a CD
audio track, instead of the data file.
Display does not function properly / No reac-
tion to operation of any of the controls
– Electrostatic discharge
• Switch off and unplug the set. Reconnect after a
few seconds
---, Er or no indication
– No CD inserted
• Insert a CD
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
– CD-R/CD-RW is blank or not finalized
• Use a finalized CD-R/CD-RW or suitable CD
Audio disc only
Note:
Make sure the CD is not encoded with
copyright protection technologies, as
some do not conform to the Compact
Disc standard.
The CD skips tracks
– CD damaged or dirty
• Replace or clean CD
– Program/shuffle is active
• Quit program/shuffle mode
Note: A CD badly scratch or dirty may result
in improper operation.
Sound skips during MP3 playback
–
MP3 file made at compression level
exceeding 320kbps
• Use a lower compression level to record
CD tracks into MP3 format
– Disc damaged or dirty
• Replace or clean disc
The USB device doesn’t play on my AZ382
– It is not set in the USB mode.
• Adjust the source selector to USB.
– The device is not securely connected to AZ382’s
USB port.
• Re-connect the device, and make sure that the
device is powered on.
– The device is not supported by AZ382, or the
audio file format stored on the device is not sup-
ported by AZ382.
• Use a compatible device/ playable audio file
format.
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service cen-
tre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no circumstances should
you try to repair the set yourself, as this will invalidate the guarantee.
AZ382_DFU_96_eng.indd 10 AZ382_DFU_96_eng.indd 10 2009-3-25 16:15:09 2009-3-25 16:15:09