Premier Mounts XUF-3760 - Manual (Page 2)

Continued from front page
7. With the help of an assistant, position the wall plate against the wall and
line up the mounting slots with drilled holes.
8. For each location, insert a lag bolt and washer into the wall.
9. Tighten each bolt with an open ended socket wrench by turning clockwise until tight.
WARNING: Do NOT over-tighten lag bolts when attaching the mount to the wall. Improper installation may result
in personal injury or damage to property.
CAUTION: Do not release the wall plate until it is properly mounted and secured to the wall.
Concrete Mounting
NOTE: The concrete anchors must be used for concrete installation.
They can be purchased at your local hardware store.
1. Begin by placing the wall plate into position against the wall, keeping it level.
2. Mark off six holes to be used for securing the mount and place the wall plate aside.
3. Next, drill holes using an electric drill and masonry bit.
4. Insert a concrete anchor into each hole.
5. If necessary, a hammer can be used to lightly tap each anchor into place so
that they are flush with the wall.
6. Once all of the anchors are in place, move the wall plate back into position.
7. Attach the nut onto the threaded shaft that is protruding from the wall.
8. Do not tighten until all nuts are in place.
How to Determine Thread Depth
Display Bracket Installation
1. To ensure optimal installation, this kit includes various
screws of different diameters and lengths.
2. Place your flat panel screen down on a soft, flat surface,
and locate the threaded mounting points that are located
on the back of the display.
3. Determine which screw is the correct length by carefully
inserting a straw, or toothpick, and mark how deep the
mounting point is.
4. If your display has a curved back or a recessed thread
mounting point, a spacer must be used.
NOTE: Select the spacer that is closest in depth to
the recess to keep your bracket as close to
the display as possible.
5. Place the spacer between the mounting bracket and
the
display.
6. If a smaller screw is being used (M4, M5, or M6)
please use a universal washer with each screw for
added
stability.
7. Attach each bracket to the display by aligning the
holes on each bracket, with the threaded inserts on
the back panel of your display, inserting the screws
through both and turning clockwise until they are fully
inserted.
8. Tighten with a Phillips head screw driver.
Final Installation
CAUTION: Two people are required for this step.
WARNING: MAKE SURE THE LOCKING SCREW IS
FLUSH WITH THE LOCKING SCREW TAB
BEFORE INSTALLATION.
1. To complete the installation of your new plasma
mount, carefully place the flat panel brackets over the
upper and lower mounting lips.
2. Use a Phillips head screwdriver to tighten the two (2)
security bracket screws (see inset below).
Produced By:
Progressive Marketing Products, Inc.
3130 E. Miraloma Ave.
Anaheim, CA 92806
800-368-9700
[email protected]
Marking
Marking
Marking the depth
Straw or Toothpick
Thread insert
Inverted flat panel display
Screwdriver
Locking Screw
Upper Mounting Lip
Lower Mounting Lip