Rear panel – Peavey Q User Manual

Page 6

frequency bands. They are adjustable within ±12 dB, or ±6dB for improved precision.

(4)

LOW CUT FILTER
This switch activates the low cut filter, which rejects frequencies below 40 Hz. Frequency roll-
off is 24 dB per octave with the switch engaged. This filter will operate even with the BYPASS
(5) switch engaged. The adjacent red LED indicates activation.

(5)

BYPASS
When this switch is engaged, the signal is routed from the INPUT (10 and 11) through the LOW
CUT FILTER (4) to the OUTPUT (8 and 9), bypassing the remainder of the unit.

(6)

POWER
This two-position rocker switch applies mains power to the unit when in the ON position. The
adjacent green LED indicates mains power activation.

(7)

IEC MAINS CONNECTOR
This is a standard IEC power connector. An AC mains cord with the appropriate AC plug and
ratings for the intended operating voltage is included in the carton.

Never remove the ground pin from any equipment. It is provided for your safety. If the outlet
used does not have a ground pin, a suitable grounding adapter should be used and the third
wire should be grounded properly. To prevent the risk of shock or fire hazard, always make
sure that the equalizer and all associated equipment are properly grounded.

NOTE FOR UK USERS ONLY:
If the colors of the wires in the mains lead of this unit do not correspond to the colored
markings identifying the terminals in your plug, proceed as follows: (1) The wire that is
colored green and yellow must be connected to the terminal that is marked by the letter E or
an earth symbol, or colored green or green and yellow. (2) The blue wire must be connected
to the terminal that is marked with the letter N or the color black. (3) The brown wire must be
connected to the terminal that is marked with the letter L or the color red.

(8)

TRS BALANCED OUTPUT
These 1/4" tip/ring/sleeve (stereo) jacks provide balanced output when used with TRS
connectors and two-conductor shielded cables. When used with a mono 1/4" (TS) phone plug,
the output is unbalanced.

Rear Panel