POSIFLEX Business Machines TP/LT- 5600 - Manual (Page 6)

Part 6
disconnection operation are not covered by product warranty!
SEPARATING MAIN UNIT
In order to settle the touch terminal properly in a point of sale system,
all the cable connections have to be routed through its base, the stand assembly.
Therefore, please observe the procedures from A to C below to separate the
main unit from the stand assembly after all cables in cable cover disconnected.
OPENING STAND ASSEMBLY
Take the adjustable stand assembly and turn
it up side down to show the bottom of the base.
Remove the bottom plate fixing screw and push the
bottom plate aside as in right picture to open.
Take the bottom plate up and the inside of
the base stand looks like this in the left picture below.
However, there will be no HDD in base for TP/LT-
5600/5700 and its picture is shown at right.
Step A: Prepare a soft clean flat surface, such as
a piece of cloth on the desk to seat the
front surface of main unit
Step C: Slide the base stand assembly
to this direction to separate
Step B: Press the Lock/Release button and meantime ...
Bottom Plate
Fixing Screw
Push Bottom
Plate This
Way To Open
Cable Exit
HDD Bracket Fixing Screw Post
Cable Passage To Main Unit For
Desktop Mount Application
Cable Passage To Main Unit For
Wall Mount Application
UPS Battery Bracket
Fixing Screw
Base Box Screw
Base Box Screw
UPS Battery Bracket
Cable tie
HDD Unit
Cable Exit
Base Box Screw
Base Box Screw
Base Box Screw