Pioneer RDS DEH-P40MP - Manual (Page 9)

Listening to the radio
2 2 2 3 3 3 1 1 1
4 5
1 Band indicator
Shows which band the radio is tuned to,
MW/LW or FM.
2 Frequency indicator
Shows the frequency to which the tuner is
tuned.
3 Stereo (5) indicator
Shows when the selected frequency is
being broadcast in stereo.
4 Preset number indicator
Shows which preset has been selected.
5 LOC indicator
Shows when local seek tuning is on.
1 Press SOURCE to select the tuner.
Press SOURCE until you see TUNER dis-
played.
2 Press BAND to select a band.
Press BAND until the desired band is dis-
played, F1, F2 for FM or MW/LW.
3 To perform manual tuning, briefly press
c or d.
The frequencies move up or down step by
step.
4 To perform seek tuning, press and hold
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by briefly pressing
c or d.
# If you press and hold c or d you can skip sta-
tions. Seek tuning starts as soon as you release
the button.
Introduction of advanced
tuner operation
% Press FUNCTION to display the function
names.
Press
FUNCTION repeatedly to switch be-
tween the following functions:
BSM (best stations memory)
—REG (regional)
—LOCAL (local seek tuning)—TA (traffic an-
nouncement standby)
—AF (alternative fre-
quencies search)
# To return to the frequency display, press
BAND.
# If MW/LW band is selected, you can only se-
lect
BSM or LOCAL.
# If you do not operate the function within about
30 seconds, the display is automatically returned
to the frequency display.
Storing and recalling
broadcast frequencies
If you press any of the preset tuning buttons 1
to 6 you can easily store up to six broadcast
frequencies for later recall with the touch of a
button.
! Up to 12 FM stations, six for each of the
two FM bands, and six MW/LW stations
can be stored in memory.
Tuner
En
9
English
Section
03