Philips Alto S06-01001 - Manual (Page 2)

MSDS -- ALTO‘ Fluorescent Lamps HL and KB
Page 2 of 4
SECTION 2: HAZARDOUS INGREDIENTS(cont'd)
OSHA (PEL) ACGIH (TLV) % by Wt.
mg/m
3
mg/m
3
TWA
If Spec or Ultralume, may have some of the above, but main phosphor components are listed
below:
Cerium Magnesium Terbium
Aluminate†
N/A 10 Approx .25%
Barium Magnesium aluminate† N/A 10 Approx .5%
Yttrium Oxide (1314-36-9)† 1.0 1.0 Approx .5%
Mercury (7439-97-6) .1 .025 < than 20 ppm
† PEL & TLV are given for magnesium, aluminum oxide, and yttrium. Barium aluminate is
not a soluble compound.
SECTION 3: CHEMICAL/PHYSICAL DATA
Not applicable. This item is a light bulb 4 ft. long, 1.5 inches in diameter. The bulb is glass, the
base is a coated aluminum. The coating is inert.
SECTION 4: FIRE AND EXPLOSION DATA
FIRE AND EXPLOSION DATA NOT APPLICABLE -- under extreme heat, glass envelope
might melt or crack.
SECTION 5: REACTIVITY DATA
Stability: Lamp is stable.
Polymerization: Not applicable.
Incompatibility: Glass will react with Hydrofluoric Acid.