Peavey 4 User Manual
Ssp pe ec ciif fiic ca at tiio on ns s p pd d
The PD
™
4 allows connection of four stereo headphones to a power amplifier using resistor isolation on each
output to prevent overloading the amplifier. If more outputs are required, any number of PD 4’s can be linked
to meet your needs. The PD 4 also has a stereo/mono switch to allow a mono signal (connected tip-sleeve on
the input) to be routed to both the left and right headphone ear cups. The PD 4 can also be used with mono
headphones by setting the PD 4 for stereo and connecting a mono source to the tip and sleeve on the input.
C
Ca
au
uttiio
on
n:: Care must always be taken when using headphones to prevent hearing damage.
S
SP
PE
EC
CIIFFIIC
CA
AT
TIIO
ON
NS
S::
IIn
np
pu
utt::
Stereo (tip-ring-sleeve) 1/4" phone jack will accept stereo or mono plug
O
Ou
uttp
pu
utt::
Four (tip-ring-sleeve) 1/4" phone jacks can also be used with mono headphones
S
Stte
erre
eo
o//M
Mo
on
no
o S
Sw
wiittcch
h::
Stereo mode route stereo signal from input to outputs, mono position routes signal on tip of input to tip
and ring of output jacks
O
Ou
uttp
pu
utt IIm
mp
pe
ed
da
an
ncce
e::
22 Ohm, suitable for low or high impedance headphones
D
Diim
me
en
nssiio
on
nss ((H
H xx W
W xx D
D))::
4.4" x 3" x 1.5"
(11.18 cm x 7.62 cm x 3.81 cm)
W
We
eiig
gh
htt:
0.5 lbs. (23 kg)
S
SP
PE
EC
CIIF
FIIC
CA
AT
TIIO
ON
NS
S P
PD
D
™
™
4
4
H
He
ea
ad
dp
ph
ho
on
ne
e D
Diis
sttrriib
bu
uttiio
on
n S
Sy
ys
stte
em
m
Features and specifications subject to change without notice.
Peavey Electronics Corporation • 711 A Street • Meridian • MS • 39301 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.com
©2003 Printed in the U.S.A. 11/03
80303113