Pioneer AVD-W6200 - Manual (Page 27)

26
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
• If this product is installed in a place where it is visible to the vehicle’s driver,
you MUST always set the [LOCATION] to the [FRONT] setting. Failure to
do so could result in distracting images being potentially visible to the driver
while the vehicle is in motion.
If this product is installed in a place where it is not visible to the vehicle’s
driver, then you may choose the [REAR] location setting.
Use of this product is subject to any government laws regarding placement
or use.
PIONEER does not accept any liability for any problems, damage or loss
incurred as a result of the product being used with an incorrect setting or in
violation of any government laws.
• To ensure proper installation, use the supplied parts in the manner specified.
If any parts other than the supplied ones are used, they may damage internal
parts of the unit or they may work loose and the unit may come off.
When the Display is Installed in the Front
• To ensure safe driving, be sure to install the display in a position that meets
the following conditions.
* Where it does not obstruct the driver’s vision and impede the safe opera-
tion of the vehicle.
* Where the front of the car is within the driver’s field of vision when look-
ing at the display.
* Where the display does not protrude above the front of the hood as viewed
by the driver.
Before Installing and Fixing
• Make temporary connections first to check that the unit and system are working properly.
• Press the RESET button with the tip of a ball-point pen or similar object, when a con-
nection is completed.
Before Affixing the Adhesive Tape
• Make sure the surface is free of moisture, dust, grime, oil, etc. before affixing the tape.