Polaroid FDM-0700A - Manual (Page 21)

- 21 -
TV Function
The auto memory will take a few minutes. The unit will search channels from the lowest
channel to the highest channel in the standard channel list. When tuning operations are
complete the unit will exit and store the channels by sequence in the memory.
During tuning, press the ◄ button to exit the auto memory.
Use the ▼、▲ direction buttons to select the desired channel from those in memory.
Timer Setup
Press the SET button on the remote control to enter Timer setup menu, the screen will
display as below:
Use the ▼、▲ buttons to select the item you want to set.
Use the ►, ◄ buttons to enter the item and to select.
Press the SET button again on the remote control to exit from the setup menu.
Timer
Use the ►, ◄ direction buttons to select ON or OFF. This function allows you to set the
start time and end time of the desired signal source. No matter what mode the unit is in,
this function will automatically start the playback of the desired signal source.
Select ON to activate the function; select OFF to disable the function.
Power on
To set the playback start time of the signal source, use number buttons to input the
desired start time in sequence of hour, minute. Press the ►, ◄ direction buttons to shift
between am and pm.
TIMER SET
Timer OFF
Power on _ _: _ _ am
Power off _ _: _ _ am
Signal CATV
Channel 002
Exit: SET