Panasonic ER2405 - Manual (Page 4)

4
English
Storing and charging the trimmer
Stor
e
Place the trimmer on the charging base when storing or charging
it.
You can fully charge the trimmer in 8 hours if it is losing speed.
The oil and the cleaning brush also can be placed in their
respective holders in the charging base.
1. Pass the power cord through one of the
cord guides on the right or left.
2. Plug the power cord into a household
outlet and place the charging base on a
flat surface.
3. Turn off the trimmer and insert it in the
charging base as illustrated.
The charge indicator lamp lights and stays
on until the trimmer is removed from the
charging base.
A full charge supplies enough power for
approximately 10 trims (5 minutes per trim
for a normal beard).
Charge the trimmer for at least 16 hours
when charging it for the first time or when it
has not been used for more than 6 months.
If the shape of the plug does not fit the
power outlet, use an attachment plug
adaptor of the proper configuration. •
•
•
•
Fixing the charging base to the wall
1. Attach two screws to the wall
as illustrated.
Do not attach the charging
base above the sink as it
may fall into the water.
Screws are sold separately.
Use screws of 2.7 mm to
3.1 mm in diameter. •
•
25mm
28mm
2. Hook the charging base onto these screws.
3. Plug the power cord into a household outlet.
Using the trimmer Use
The following is the symbol for a wet trimmer. The
symbol means the hand-held part may be used in a
bath or shower.
Trimming your moustache
1. Apply a few drops of the oil to the blades.
2. Grasp the sides of the comb
attachment and move it to the
desired trimming length (between
3 mm and 15 mm).
Indicator Trimming length
1 3 mm (1/8˝)
2 6 mm (1/4˝)
3 9 mm (3/8˝)
4 12 mm (1/2˝)
5 15 mm (5/8˝)

