Philips CCB190CN - Manual (Page 10)

10 Automatic Channel Setup
Although the TV/VCR may automatically memorize the channels
you receive when you turn it on for the first time, you may set up
channels again by following the steps below.
1
Press the MENU button.
3
Press the PLAY/▲ button or the STOP/▼ button to select
PRIM. SETUP, then press the F.FWD/B button.
PRIMARY SETUP
> SELECT LANGUAGE
AUTO PROGRAMMING
CH MEMORY REVIEW
VOLUME BAR
[ON]
SET CLOCK
SELECT KL CHOOSE B
TO END PRESS EXIT
4
Press the PLAY/▲ button or the STOP/▼ button to select
AUTO PROGRAMMING, then press the F.FWD/B but-
ton. AUTO CH PROGRAMMING ... will appear on the screen.
The TV/VCR will memorize its available channels.
• Line Input mode will always be
stored in the TV/VCR’s memory as
channel 00. You cannot delete it.
• You can not set CABLE to YES or
NO while the TV/VCR is in Line
Input mode.
Helpful Hints
5
Wait for a few minutes. When setup is complete, CHANNELS
ARE SET will appear on the screen. Then the programming of the
lowest channel number placed in the TV/VCR’s memory will
appear on the screen. Now, when you press the CH(annel) m/n
button, you will scan only through channels you receive.
5 Wait for the TV/VCR to set up
channels.
1
2-4
VOL.
CH.
3 2 1
6 5 4
9 8 7
0
POWER
STATUS/EXIT
TRACKING REC/OTR
SPEED MEMORY
ALT. CH
PAUSE/STILL
MUTE
F.FWD REW
PLAY
STOP
SLEEP/WAKE UP
MENU CLEAR
> PRIM. SETUP
VCR PROGRAM
VCR SETUP
CAPTION
REMINDER
BRIGHTNESS
PRESS B
2
Press the PLAY/▲ button or the STOP/▼ button to select
CABLE. Press the F.FWD/B button or the REW(ind)/{
button until YES (if you have a cable connection) or NO (if
you do not have Cable TV service) appears beside CABLE.
TO ADJUST PRESS { / B
> CABLE
SMARTLOCK
REVIEW
EXIT
PRIM. SETUP
VCR PROGRAM
YES