Philips Sonicare 7800 - Manual (Page 10)

Quadpacer\ 30-second interval timer
C
◗ Quadpacer makes sure that you brush all sections of your mouth
evenly and thoroughly.At 30-second intervals (at 30, 60 and
90 seconds in case of a 2-minute brushing cycle), you will hear a
short beep and a pause in brushing action.This is your signal to
move to the next section of your mouth.
Programmable Quadpacer timer (series 7800)
The Programmable Quadpacer timer offers you the option of
customizing the Quadpacer performance in 1 of 3 ways:
◗ You may opt to keep the factory default setting of a 2-minute
brushing time with Quadpacer beeps activated.
◗ You may choose to extend your brushing time to 2.5 minutes by
adding an additional timing interval of 30 seconds.
◗ You may choose a 2-minute brushing time, but with the Quadpacer
beeps turned off.
To change the Quadpacer settings:
1 Place the handle in the charger that is plugged into a live
electrical outlet.
C
2 Press the Dual Speed Control button briefly and note which
LED lights up.
3 Press and hold the Dual Speed Control button. Continue to
hold the button while the LEDs slowly cycle through the timing
interval setting options:
C
◗ Green LED in position 4: Quadpacer active (factory default
setting).
C
◗ Green LED in top (5th) position: 2.5 minute setting - Quadpacer
active with additional timing interval of 30 seconds.
ENGLISH 10
1
3