Philips SC250SBC User Manual
Page 9
Problem solving
Problem
Solution
Temperature too low.
• Turn the click-step control knob
4 to the right until the indicator
lamp lights up red to start the
heating up again.
• Check ring filling and start
temperature.
Temperature too high.
• Lower the adjustment setting.
• Check ring filling and start
temperature.
The jar has not been
Stir the contents from time to time
heated correctly.
while heating. Check that the
click-step control knob is in the
position.
Unit does not warm up.
Wait 15 minutes between
consecutive uses to allow the safety
cut-out to reset.
The indicator light
This is normal; it may turn on or off
switches on and off
while heating.
while keeping warm.
Indicator light does not
Shield indicator from ambient light
seem to light.
to improve visibility.
The bottom of the tank
Hard water deposits are normal
is spotted.
and may increase if your water is
very hard; remove the deposits
periodically with white vinegar
(see maintenance).
ENGLISH
9
SBC SC250_booklet.qxd 02-02-2004 16:04 Pagina 9