Pentax 300X - Manual (Page 7)

MOUNTING THE FLASH ON THE CAMERA
1. Turn off the Main Switch.
2. Loosen the Wheel Lock by
turning it counterclockwise,
grip the bottom part of the
flash and clip the Strobo Foot
into the camera's accessory
shoe. Make sure the foot goes
all the way in because the flash
might not function properly if
it is only part of the way in.
then turn the Wheel Lock
clockwise to lock the flash
securely in place.
3. To dismount the flash, loosen
the Wheel Lock by turning it
counterclockwise then grip the
bottom part of the flash and
slide the Strobo Foot out.
TAKING FLASH
PICTURES (I)
• Setting the camera's
shutter speed
1. If you are using the flash with
a Fujica AX-series camera, the
camera's shutter speed will
automatically switch to 1/60
sec. (X-sync) as soon as it is
fully charged, regardless of
where the shutter speed dial
has been set (except "B").
2. If you are using it with the
Fujica AZ-1, the camera's
shutter speed will automatical-
ly switch to 1/60 sec. (X-sync)
with the shutter speed dial set
to AE as soon as it is fully
charged.
3. If you are using it with other
cameras, set the camera's shut-
ter speed to (1/60 or 1/125
sec.) (X-sync.).
7