Nstallation and, Peration – Plinius Audio CD101 User Manual
Page 12
12
I
NSTALLATION AND
O
PERATION
PLACEMENT AND VENTILATION
Ventilation through and around your Plinius CD101 Compact Disc Player should be kept unimpeded, so
ensure that the heat vents (slots in the lid) are not covered or restricted in any way.
The Plinius CD101 design incorporates a very high level of mechanical de-coupling of the outputs.
However, it can still be influenced by acoustical feedback in the operating environment. The use of
acoustic cones or isolators or a suitable equipment stand or table, may further enhance the performance
of this Compact Disc player. Consult your PLINIUS dealer for further advice if required.
MAINS VOLTAGE CONNECTION
Firstly, check that the mains supply voltage printed on the rear of this Compact Disc player is similar to
the mains supply voltage in your area. If in doubt, please consult your PLINIUS dealer.
Mains supply power connection is via the supplied plug-in lead. A standard IEC socket connects the
mains power at the Compact Disc player end, while a local mains plug is required at the wall end.
The wiring code used inside all Plinius product is:
Green
to
Earth/Ground
Blue
to
Neutral
Brown
to
Phase/Live
Should a ‘local’ plug need fitting to the wall end of the lead, ensure that a suitably qualified service
technician wires the plug correctly.
IMPORTANT:
DO NOT POWER UP YOUR COMPACT DISC PLAYER UNTIL YOU HAVE
CONNECTED YOUR INPUT/OUTPUTS CORRECTLY FOR YOUR
SYSTEM, (AS EXPLAINED IN THE NEXT SECTION).