Precor p20 - Manual (Page 65)

Chapter
1
Assembling the AMT
Important: The instructions in the following procedures are
described from the perspective of a person standing directly in
front of the equipment (that is, on the opposite side of the
control console from a person using the equipment). These
descriptions may not match the names of certain parts in the parts
list, because such parts are named relative to the back of the
equipment.
To prepare the AMT for assembly:
 Open the box and assemble the components in the
sequence presented in this guide.
 Assemble and operate your equipment on a hard, level
surface in the area intended for use.
Important: Do not grasp any plastic parts of the unit while
lifting or moving the unit. The plastic parts are non-structural
covers and are not capable of supporting the weight of the
unit.
 Provide ample space around the unit.
 Assemble the equipment according to the guidelines in
this manual to ensure you do not void the Precor Limited
Warranty.
Important: Any damage caused during installation is not
covered by the Precor Limited Warranty.
 Attach all fasteners and partially tighten them. Do not
fully tighten fasteners until instructed to do so.
WARNING
You will need assistance to assemble this unit.
DO NOT attempt assembly by yourself.