Panasonic DMC-TZ1 - Manual (Page 19)

Preparation
19
VQT0V40
• Refer to [WORLD TIME] (P61) for
information about setting the local time
at the travel destination area.
3 Press [MENU/SET] several times
to close the menu.
• Turn the camera off after finishing
setting the clock. Then turn it on and
check that the clock setting is correct.
∫ Changing the clock setting
1 Press [MENU/SET] to display the menu
and then press 2.
2 Press 4 to select the [SETUP] menu
icon [ ] and then press 1.
3 Press 3/4 to select [CLOCK SET] and
then press 1. Set as shown previously.
• When a fully charged battery has been
inserted for more than 24 hours, the clock
setting is stored (in the camera) for at
least 3 months even if the battery is
removed.
• You can set the year from 2000 to 2099.
The 24-hour system is used.
• If the date is not set in the camera it will
not be printed when you use a photo
printing service, even if the store provides
a date printing option for your
photographs. (P85)
About the Setup Menu
• Set items as required. (Refer to P20 to 24
for each menu item.)
• Menu items differ depending on the mode
selected with the mode dial (P5).
The following example shows how to set
[BEEP] when normal picture mode [
] is
selected.
• Select [RESET] to return the settings to
the initial settings at the time of purchase.
(P23)
1 Press [MENU/SET] and then
press 2.
2 Press 4 to select the [SETUP]
menu icon [ ] and then press 1.
SETUP
EXIT MENU SELECT
OFF
AUTO REVIEW
0 n MONITOR
WORLD TIME
TRAVEL DATE
CLOCK SET
1 /
4
1SEC.
EXIT MENU SELECT
REC 1 /
3
AUTO
AUTO SENSITIVITY
PICT.SIZE
QUALITY
ASPECT RATIO
MENU
SET W.BALANCE
SETUP
EXIT MENU SELECT
OFF
AUTO REVIEW
0 n MONITOR
WORLD TIME
TRAVEL DATE
CLOCK SET
1 / 4
1SEC.
VQT0V40ENG.book 19 ページ ２００６年２月２７日 月曜日 午後１時１９分