Panasonic ES2262 - Manual (Page 3)

3
English
Important
Before use
This WET/DRY body shaver can be used for wet shaving with
soap lather or for dry shaving. Use the watertight shaver in the
shower and clean it in water. The following is the symbol of Wet
body shaver. The symbol means that the hand‑held part may be
used in a bath or shower.
We recommend using the shaver head for close shaving and
using the pop up trimmer to cut longer hairs.
Using the shaver
Caution ‑ The outer foil is very thin and can be damaged if not
used correctly.
Check that the outer foil is not damaged before using the
shaver. Do not use the shaver if the outer foil is damaged
because you will cut your skin.
Be sure to lubricate the outer foil or the blades before using
the shaver. Failure to do so may cause the shaver to pull your
hairs or damage to skin.
Do not apply strong pressure to the skin, repeatedly rub over
the same area, hold in one spot on the skin, or apply in a
jabbing motion when using the shaver. Doing so may cause
damage to skin, inflammation or increased pain.
Do not use for facial shaving.
Charging the shaver
Dry the shaver completely before charging it.
Do not attempt to use a charger other than the included one
which is specifically designed for this model. Use only the
included charger.
Keep the charger away from water and handle it only with dry
hands.


•
•
•
•

•
•
•
The shaver may become warm during use and charging.
However, this is not a malfunction.
Hold the adaptor when disconnecting it from the household
outlet. If you tug on the supply cord, you may damage it.
The supply cord cannot be replaced. If the cord is damaged,
the appliance should be scrapped.
Do not charge the shaver where the temperature is below
32 °F (0 °C) or above 104 °F (40 °C), where it will be exposed
to direct sunlight or a heat source, or where there is a lot of
moisture.
Charge the shaver for at least 16 hours when charging it for
the first time or when it has not been used for more than 6
months.
Cleaning the shaver
When you clean the shaver with water, do not use salt water
or hot water. Wipe it with a cloth dampened with soapy water.
Do not use thinner, benzine or alcohol.
Storing the shaver
Store the charger in a dry area where it is protected from
damage.
Do not disassemble the appliance. Take it to a qualified
service person when service or repair is required.
SPECIFICATIONS
Power source: 100‑120 V AC, 50‑60 Hz
(Only plug the charger in a 100‑120V AC outlet.)
Motor voltage: 1.2 V DC
Charging time: 8 hours
This product is intended for household use only.
•
•
•
•

•

•
•