Philips PDCC-XP-0845 - Manual (Page 20)

20
English
TECHNICAL DATA
Dimensions 210 x 158 x 39.5 mm
Weight 0.82 kg
Power supply INPUT: 100-240V 50/60Hz 0.3A
OUTPUT: DC 9V 1A
Power consumption 9W
Operating temperature range 0 - 45°C
Laser wavelength 650nm
Video system PAL
Frequency response 20Hz ~ 20KHz ± 1dB
Signal/noise ratio ≥ 80dB
Audio distortion + noise ≤ -80(1KHz)
Channel separation ≥ 80dB
Dynamic range ≥ 80dB
Audio out (analog audio) Output level: 2V ± 10%
Load impedance: 10KΩ
Video out Output level: 1Vp - p ± 20%
Load impedance: 75Ω
PHILIPS reserves the right to make design and specification
changes for product improvement without prior notice.
Modifications not authorized by the manufacturer may void users
authority to operate this device.
All rights reserved.
TROUBLESHOOTING
Symptom Remedy
Disc can’t be played – Ensure the disc label is upwards.
– Clean the disc.
– Check if the disc is defective by trying another
disc.
The player does not – Aim the remote control directly at the
respond to the remote sensor on the front of the player. Avoid all
control obstacles that may interfere with the signal
path. Inspect or replace the batteries.
Distorted or B/W – Use only discs formatted according to the
picture with DVD TV-set used (PAL).
Player does not respond – Operations are not permitted by the disc.
to all operating commands – Refer to the instructions in the disc inlay.
during playback
Player feels warm – When the player is in use for a long
period of time, the surface will be heated.
This is normal.
Display goes dimmer when – The unit is saving power to ensure longer
AC is unplugged
playtime with battery. It is normal.
Adjust the brightness using the rotary bright
ness control.
This set complies with the radio interference requirements of the
European Union.
P001-021_PET737_58_Eng 2008.11.10 16:17 Page 20